RELIABILITY TEST CONDITIONS
WIRE WOUND CHIP INDUCTORS TYPE
FOR SMD322522/453232 / SMTSDR322520/453226 / SMDCHGR0603/0805/1008/1210 / SMDFSR1008 / SMTSC
|
Item (項目) |
Required Characteristics (要求) |
Test Method / Condition (測試方法) |
Electronic characteristic test of major products
主要產品電特性測試 |
Refer to catalogue of specific
products
參照具體產品目錄頁 |
Refer to catalogue of specific
products
參照具體產品目錄頁書 |
Overload test
Reference documents:
JIS C5311-6.13
過負荷試驗 |
1.During the test no smoke, no peculiar,smell, no fire
2.The characteristic is normal after test
1.試驗過程中無冒煙,異味,著火等,
2.試驗後產品特性正常. |
Apply twice as rated current for 5 minutes.
通兩倍額定電流 5 分鐘 |
voltage resistance test
Referencedocuments:
MIL-STD-202G Method 301
絕緣耐壓測試 |
1.During the test no breakdown
2.The characteristic is normal after test
1.試驗過程中無擊穿
2.試驗後產品特性正常 |
1.For parts with two coils
2.DC1000V,Current:1mA,Time:1Min.
1.只針對SMT二繞組以上
2.電壓DC1000V,電流1mA,時間1分鐘. |
Curve of Heat endurance of Reflow soldering test |
|
A test is made under the conditions mentioned above. And it is left 1 hours in the normal temperature and humidity. After that, no mechanical and electrical defeat should be found
out. The reflow condition is according to the machine used by our company. |
